Round rail fence and gate installed around a Colorado home

Home/Home & Yard

Residential fence installation · Central Colorado Fences built for Colorado ground.

Wind, frost heave, clay, decomposed granite, and 300 days of sun. Every fence we build is specified for what this state actually does to lumber and vinyl.

A new cedar privacy fence with a braced walk gate
Most requested

Cedar privacy fence

The classic Colorado backyard fence, done properly. Western red cedar or treated pine, concrete-set posts, and framing that stays square through freeze and thaw.

  • Board-on-board, shadowbox, stockade, and horizontal slat
  • Posts set 30–36″ deep in concrete, below frost line
  • Hot-dipped galvanized or stainless fasteners — no rust bleed
  • Optional lattice tops, trim caps, and stain/seal packages
A peeled-log railing around the deck of a log home

Custom wood picket

Cut and built on site rather than ordered in panels — peeled log, milled picket, or a profile drawn to match the house.

  • Custom pickets, toppers, and post caps
  • Matched to existing fence or architecture
  • Rustic peeled-log and dimensional lumber builds
A black vinyl rail fence with wire infill running along a drive

Vinyl

Heavy-wall vinyl for homeowners who want a fence they never have to stain. Steel-reinforced bottom rails and routed posts, not the box-store gauge.

  • Privacy, semi-private, and picket profiles
  • UV-stabilized, colorfast white, tan, and khaki
  • Manufacturer lifetime material warranty
A split rail fence with wire backing turning a corner in a green backyard
Acreage lots

Split rail

The boundary that doesn’t close off the view. Two- and three-rail split rail for acreage lots and front boundaries — with wire mesh backing where dogs or small stock are part of the picture.

  • Two-, three-, and four-rail configurations
  • Optional welded or woven wire backing
  • Set to follow rolling ground instead of stepping down it
  • Matching walk gates and drive gates

Fencing acreage or livestock instead? That work has its own page — ranch & livestock fence.

Also handled

The details that decide whether a fence lasts.

Gates & hardware

A fence is judged by its gates. Wide spans get welded steel frames instead of butt-joined wood, and every gate gets hardware rated well past what it will actually carry.

  • Single, double, and drive-through gates up to 16 feet
  • Steel-framed leaves on any span over six feet
  • Self-closing pool-code hinges and latches
  • Keypad, intercom, and automatic opener rough-in

Repair & replacement

Not every job needs a full teardown. We’ll tell you straight whether a section repair is the honest answer — and we’ll say so even when the bigger job would pay us more.

  • Storm and wind damage repair
  • Leaning post resetting and rotted post replacement
  • Gate re-squaring and hardware upgrades
  • Section matching on existing fence lines

Site & prep work

Most fence problems start before the first post goes in. We handle locates, layout, and grade so the finished line reads straight from the street.

  • Utility locates and property-line staking coordination
  • Old fence demolition and haul-off
  • Rock drilling and hard-ground post setting
  • HOA and municipal permit paperwork

Common questions

Straight answers, before you ask.

How much does a new fence cost?

We don’t publish numbers, because the honest answer depends on things we can only see on site. What drives it: material and height, how much rock is in your ground, the number of corners and gates, how much old fence has to come out, and drive time. We walk it, measure, and hand you an itemized written price before anything is scheduled.

How long does a typical fence take?

Most residential yards are a two- to four-day build once we start. We don’t double-schedule crews, so the days we give you are the days we’re actually on your property.

What about utility locates?

We schedule locates before any digging happens, every time, on every job. It’s not optional and it’s never billed as an extra.

Do you warranty the work?

We stand behind our workmanship, and materials carry their manufacturer warranties. If something isn’t right, you call us and we come back — that’s the whole standard.

Do you handle permits and HOA approval?

Yes. We’ll pull municipal permits where they’re required and put together the drawings and material specs your HOA needs for approval.

Free estimate

Not sure which fence you need?

Tell us about the property and what you’re trying to solve. We’ll walk it with you and recommend the option that actually fits — not the most expensive one.

Want a detailed price? Fill out the free estimate →